RedMax GZ3500T Bedienungsanleitung PDF herunterladen (Seite 11)

GZ3500T

US-11

Chain oil flow adjusting

shaft

Rich

Lean

Idle adjusting

screw

H needle

L needle

Chain oil

Throttle

interlock

Throttle lever

Switch

Fuel

Chain oil

Choke

closed

Open with

throttle lever

Choke

open

It is very dangerous to run a chainsaw with mounts broken

or any missing parts.

Before starting engine, make sure that all the parts includ-

ing bar and chain are installed properly.

■ STARTING THE ENGINE

Normal start

1. Fill fuel and chain oil tanks respectively, and tighten

the caps securely.

2. Continuously push the priming bulb until fuel comes

in the bulb. Then press additional 5 times.

3. Set the switch to “I” position.

4. Turn the choke knob to the closed position.

When restarting immediately after stopping hot en-

gine, choke knob should be in the open position.

5. While holding the saw unit securely on the ground,

pull the starter rope using short strokes vigorously.

Do not start the engine while the chain saw hangs in

one hand. The saw chain may touch your body. This

WARNING

NOTE

The chain oil flow can be changed by inserting a

screwdriver in the hole on bottom of the clutch side.

Adjust according to your work conditions.

The oil tank should become nearly empty by the time

fuel is used up. Be sure to refill the oil tank every time

when refueling the saw.

The adjustment range of the discharge is 90°. Pay at-

tention not to turn any further, as this may damage the

adjuster of the oil pump.

■ ADJUSTING THE CARBURETOR

The carburetor on your unit has been factory adjusted,

but may require fine tuning due to a change in operat-

ing conditions.

Before adjusting the carburetor, make sure that the pro-

vided air/fuel filters are clean and fresh and the fuel prop-

erly mixed.

When adjusting, take the following steps:

Be sure to adjust the carburetor with the bar chain at-

tached.

WARNING

NOTE

■ CHECKING THE OIL SUPPLY

Make sure the bar and the chain is in place when checking the

oil supply.

If not, the rotating parts may be exposed. It is very dangerous.

After starting the engine, run the chain at medium speed

and see if chain oil is scattered off as shown in the fig-

ure.

is very dangerous.

6. When engine has started, turn the choke knob to

the closed position and then pull the starter again to

run the engine.

7. Allow the engine to warm up with the throttle lever

pulled slightly.

WARNING

7. Operating the Engine

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare

RedMax GZ3500T Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kraftkettensägen RedMax GZ3500T