Redmax EB6200 Bedienungsanleitung PDF herunterladen (Seite 9)

■ CONTROL ARM

1.Hold the upper end of the control arm in

hand and, while pulling it away from the

unit, rotate arm forward (anti-clockwise as

the arrow direction) until it clicks. To fold

the arm, reverse the order.

■ STARTING ENGINE

• Avoid operating the blower with the

flexible tube and swivel joint

disconnected. That will reduce the

cooling air and the engine could be

damaged by overheating.

1.Push the primer bulb until fuel flows out in

the clear tube.

2.When the engine is cool, close the choke.

3.Set the throttle lever in 1/3 open position.

4.To start, hold the top of the blower firmly

with your left hand. Pull the starter knob

slowly until you feel it engage and then

give it a vigorous strong pull.

IMPORTANT

Operation

• Avoid pulling the starter rope out to its

full extension. Do not allow the starter

rope to snap back. Rewind the rope

slowly. This will prevent premature

damage to the starter.

• Do not let a person stand near the

blower or the exhaust port.

5.Once the engine is running, gradually open

the choke if it was set closed, and let the

engine run at idle speed for a minute to

warm it up.

• When the engine fails to start after several

attempts due to overchoking, open the

choke and repeat pulling the rope.

■ ADJUSTING IDLE SPEED

• The idling speed is set for 2000 rpm at the

factory. If it is necessary to adjust the idle

speed, use the adjustment screw on the

top side of carburetor.

■ STOPPING ENGINE

• Move the throttle lever to the idling position

and press the stop switch (red button) until

the engine comes to a complete stop.

NOTE

IMPORTANT

❲

7

❳

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Kommentare zu diesen Handbüchern

Keine Kommentare